Calibration
Last updated
Was this helpful?
Last updated
Was this helpful?
To guarantee accurate measurements, the Otii hardware, both the Otii Arc Pro and the Otii Ace Pro can be calibrated when required. It is recommended to calibrate before any measurement requiring the best accuracy, especially ultra-low currents.
Open the Otii 3 Desktop App, and open/create a project.
In the Otii 3 Desktop App toolbar, navigate to Device > Calibrate.
Once the calibration starts, the following behavior will be observed on the Otii hardware:
Otii Ace Pro: the LED will start blinking white slowly, then turn off for a few seconds and turn on blue—the same state it was before the calibration.
Otii Arc Pro: It will restart when the calibration is finished.
Open the Otii 3 Desktop App, and open/create a project.
In the Otii 3 Desktop App toolbar, navigate to Device > Calibrate all devices.
Once calibration starts, the same behavior on the Otii hardware previously described on this page can be observed.