Analog
Last updated
Last updated
The analog viewer shows analog data recorded from the current, voltage and power channels. There is one analog view for each analog measurement, showing all the available recordings for each measurement in different colors.
At the top of the all viewers there is a scroll bar that show an overview of all the recordings in the project, and a white rectangle that represents the current view of the data.
You can scroll horizontally by dragging the white rectangle, and you can zoom horizontally by dragging the left and right border of the rectangle.
Below the scroll bar is the graph showing part of the actual recordings. You can in addition to the scroll bar use the graph tools to navigate in the graph and to select data to analyse.
The context menu is displayed by right-clicking anywhere in the graph. The following options will be avaible the the analog view:
Select all: select all data.
Clear selection: clear the current selection.
Zoom to selection: when having a selection and right-click and select Zoom to selection, then the selection will fill the whole graph. This is the quickest way to zoom to the part that's desired to be analyzed.
Set value range: the time range to be evaluated can be adjusted from and to a specific time. This time will be the same for all the graphs shown.
Set time range: according to the channel graph selected, the time range to be evaluated can be adjusted from and to a specific time.
Crop active recordings: the selected recording will be cropped, keeping the selection, and all other recordings will remain unchanged. If the undo history hasn't cleared up, the crop can be undone by pressing Ctrl-Z/ ⌘-Z.
Crop all recordings: this will crop all the recordings, even the recordings that are not selected, keeping the data within the selection. If the undo history hasn't cleared up, the crop can be undone by pressing Ctrl-Z/ ⌘-Z.
In the top right corner of the graph are the statistics shown. If there is an active selection the statistics will be calculated on the data within the selection:
When the is no active selection, the calculation depends on the statistics setting. If you have chosen project, the statistics will be calculated for the project, and if you have chosen view it will be calculated for the data visible in the viewer.
By default the statics will be calculated for the active recording. By pressing the arrow in the top left corner of the statistics window, statistics will be shown for all of the visible recordings.
